Top 10 common forklift crashes ， forklift operation need to focus on these issues ！.

Top 10 common forklift crashes ， forklift operation need to focus on these issues ！.

Blog Article

Don't undervalue the forklift at the workplace. If the operation is not good, there will certainly be significant accidents in mins, and there are several accidents involving forklifts.

Instance 1: The forklift freight blocked the driver's view, and the person in front could not be found, causing a moving accident.
Instance 2: In order to maintain the balance of the forklift when raising hefty products, the employees used their body weight as the counterweight, which almost created casualties.
Situation 3: The size of the forklift freight goes beyond the permitted width of the route and hangs on the roadside rack, which practically causes an accident.
Situation 4: Forklift is speeding up and surrender throughout a turn.
Case 5: The forklift chauffeur did not observe the pedestrian, and the pedestrian did not notice the forklift.
Instance 6: The forklift lifts the employees unlawfully, the forklift vehicle driver does not put on the seat belt, the forklift lifter falls and the driver is crushed when the forklift rolls over.
Instance 7: The forklift motorist did not wear a safety belt and dropped from the vehicle when it rolled over and was squashed.
Forklift procedure ought to focus on these matters ：.

Start.
1. Prior to starting, observe the environments, and after verifying that there are no challenges that hinder the safety of driving, beep the horn first and then begin.
2. For automobiles with hydraulic (air pressure) brakes, the brake hydraulic pressure ( atmospheric pressure) scale need to be risk-free before beginning.
3. When the forklift starts with a lots, the driver ought to first validate that the tons is steady and trustworthy.
4. The begin has to be sluggish and consistent.

Driving.
1. When driving, the height in between the bottom end of the fork and the ground should be kept at 300mm-400mm, and the mast should be slanted in reverse. .
2. Do not lift the fork expensive when driving. When entering and leaving the task site or while driving, take care that there will be no challenges in the sky. When the lots is taking a trip, the fork has to not be raised expensive, which will certainly influence the security of the forklift. .
3. After discharging, the fork must be lowered to the typical driving placement prior to driving. .
4. When turning, if there are pedestrians or vehicles nearby, the driving signal must be released initially. High-speed doglegs are prohibited. High-speed sharp turns will certainly create the automobile to shed side security and tip over. .
5. When the forklift is downhill, it is purely restricted to turn off the fire and slide, and it is prohibited to brake instantly while driving with lots unless there are special scenarios.
6. When the forklift is running, it has to follow the web traffic rules in the manufacturing facility and have to maintain a particular safety and security range from the car ahead. .
7. When the forklift is running, the tons should remain in the most affordable placement that does not impede the driving, and the gantry needs to be correctly slanted back. The tons will not be raised except when piling or loading. .
8. The height of the load must not obstruct the vehicle driver's sight. In unique conditions, when the item affects the forward vision, drive at a low speed when reversing.
9. It is forbidden to turn on the ramp, nor to drive throughout the ramp. .
10. The secure driving rate of the forklift in the factory area is 5 km/h, and it must drive safely at a low speed when entering the production workshop location. .
11. When the forklift is raised, raised or driven, it is forbidden for employees to base on the fork to hold products and play a balancing function. .
12. If issues are discovered, they will be fixed and reported in a timely manner, and they will certainly never ever operate with illnesses or hide them.

packing and unloading.
1. When fork-loading things, the distance in between the two forks should be readjusted as needed to make the load of both forks balanced and not manipulated, and one side of the item ought to be against the rack. .
2. It is forbidden to collaborate with a single fork or use a fork top or draw. In special situations, security warning signs need to be set up to remind bordering pedestrians. .
3. In the process of filling and dumping items, the forklift has to be braked with the brake. .
4. The rate of the automobile must be slow and constant. Be careful not to roll the wheels on the dunnage, so as not to extend the rolled objects and harm people. .
5. When utilizing a fork to fork the goods, the fork should be as deep as possible under the tons, and it should be noted that the fork pointer should not touch various other items or items. The lots must be supported with marginal back tilt of the gantry so that the tons does not glide in reverse. The mast can be slanted ahead somewhat when the lots is lowered to allow for simple placement of the load and extraction of the forks. .
6. It is restricted to fork goods at high speed and hit hard things with the fork head. .
7. When the forklift is working, it is forbidden for individuals to loaf the fork, so as to prevent the collapse of the goods and injure individuals. .
8. Straining is restricted, and it is forbidden to use forks to raise personnel to participate in high-altitude operations to avoid high-altitude dropping crashes. .
9. It is not permitted to use the brake inertia to slip, place, round or roll items. .
10. It is not enabled to make use of forks to select, transform pallet dump.

Leaving .
1. It is restricted to leave the forklift when the things on the fork impend. Prior to leaving the forklift, you should discharge the goods or reduced the fork structure.
2. Draw the parking brake deal with to dead or depress the parking brake button.
3. The engine is shut off and the power is cut off. (Except for special situations, such as the motorist does not leave the automobile's view and does not go beyond 1 minute).
4. Eliminate the secret. .

Forklift Operation Precautions.
1. Before and after the forklift procedure, the look needs to be examined, and gas, lubricating oil and air conditioning water need to be added.
2. Examine the security efficiency of beginning, running and stopping.
3. Inspect whether the lights and horn signals are total and efficient.
4. Throughout the procedure of the forklift, inspect whether the pressure and temperature level Electric Forklift Truck for Warehouse are regular.
5. After the Stand-on Electric Pallet Stacker forklift is running, the outside leak should also be examined and the seals must be replaced in time.

Forklift Safety Operation Specifications.
1. You must examine before leaving the automobile;.
2. When you experience a person before you during driving, you need to send out a signal at a distance of 5 m;.
3. The driving rate in the manufacturing facility does not surpass 5 km/h;.
4. When driving, the nadir of the freight ought to be 0.3 m ~ 0.4 m in the air;.
5. The transforming need to not be as well sharp to avoid the propensity of " cost-free switching";.
6. Running up and down the incline must be slow and consistent, and no activating the incline is enabled.
7. Do not drive throughout the gradient. When the gradient is greater than 10%, the car ought to be driven in reverse when going downhill;.
8. When the forklift workers carry the goods and progress, if they run into huge or heavy items and go to the motorist's line of sight, they must take the reversing exercise
.
The "Eight Prohibitions" should be complied with in the procedure.
1. Single fork procedure is not permitted.
2. It is not allowed to lift the goods for long distance driving.
3. It is not allowed to grab the goods by turning over the pallet with the fork.
4. It is not enabled to straight shovel chemicals, flammables and other hazardous chemicals with forks.
5. It is not allowed to make use of inertia force to get the goods.
6. It is not permitted to utilize braking pressure to expatriation round or easy-to-roll objects.
7. It is not enabled to bring individuals to work on the pallet or fork, and it is strictly prohibited to stand under the fork after the fork is elevated.
8. Do not drive side to side on slopes
.
Car park is not allowed under the following problems.
1. Curves, narrow roads, railway crossings;.
2. Areas with a longitudinal incline more than 5%.
3. When there is an obstacle on one side of the road, the opposite side of the area with the exact same size as the challenge should be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：info2@onen.cn
Phone：+86 13827083844